|LT. 1||PLS.1000||£19.47 VAT included, if applicable|
|LT. 1 x 2||PLS.2000|
|LT. 1 x 5||PLS.5000|
PLASTER is a non-toxic and ecological fluid, suitable for cooling plastics during milling activities.
Spray the product on the part being milled, with a number of sprays sufficient to cover it.
In addition, the legendary Plaster 1.0 is also suitable for hand polishing the surface after routing.
Simply soak a dishcloth with the product and distribute it evenly over the surface to be polished.
The product is not considered dangerous according to EC Regulation 1272/2008 (CLP). However, handle according to good working practices and preferably with protective gloves.
IN CASE OF CONTACT WITH THE SKIN:
Wash thoroughly with soap and water.
IN CASE OF CONTACT WITH EYES:
Wash immediately with plenty of water and consult a doctor.
IN CASE OF INGESTION:
Do not induce vomiting under any circumstances. Seek medical advice immediately.
IN CASE OF INHALATION:
Remove the injured person to fresh air and keep warm and at rest.
Completa al meglio il tuo lavoro con
Gli altri fresatori hanno visto anche
FAQ - What you need to know to be a winning miller
From today you can find the parameters of your CNC router Bits directly in your account.
Just be registered at the time of purchase and, depending on the milling cutter purchased, you will unlock the code in the parameters section that you can find here
If you have not logged in before completing your order and would like to receive the specific working parameters for your processing, you must write us an email to [email protected] specifying the following:
- order number
- type of wood to be processed
- available milling machine (manual, vertical on bench, spindle moulder, CNC), maximum power and speed (maximum and if fixed or adjustable)
- brief description of the work to be carried out
In this way our experienced engineers and technicians will have all the necessary information to communicate to you in a short time the working parameters ideally correct for your specific case.
BITTOP is an exclusive product that serves to optimize and protect your Fraiser cutter, helping it to last three times longer than ALL OTHER alternatives.
It was created to make the most of your milling cutter, a special concentrated formula designed by us that can maintain and preserve the tools, greatly increasing their durability.
How does it work?
Once the cutter has been cleaned (with products such as TOOLSNER 3.0), before placing it in its box, just a few more drops, scattered with a finger or directly from the bottle (not with the cloth, would not remain in the cutter but would be absorbed by it ... and do not worry that it is environmentally friendly and non-toxic) in the stem and head, to keep it in perfect condition until the next use.
Here's that in a few seconds, every time you will have a tool at the height and always well guarded, ready to face the most extreme of processing.
Of course, be careful not to cut yourself, we decline any responsibility.
When am I entitled to receive BITTOP?
BITTOP is an exclusive FRAISER and is not sold separately, you can only have it with the purchase of a Fraiser cutter. (not even with an accessory or non-fraiser bit, only with the purchase of a cutter directly shipped from our store)